Specifications

• 4 brushes
• Minimum glass size: W100xL320mm
• Glass thickness up to 6mm without adjustment
• Stainless steel: Washing section, brush shafts, screw, nuts and bolts
• Chain gears and bearing pillow blocks
• Variable speed up to 0-4meter/min
• Drive motor mounted on top of washer to prevent contact with water

Entry Roller

• 1600mm manual/auto entry Roller

Wash Section

• Two sets 160mm diameter brushes with stainless steel shaft
• Recirculation water supplied by spray lines with birdseye holes
• Tank section has a recirculation pump

Dryer Section

• 1 pair of stainless steel air knives
• Air is supplied from a high pressure blower mounted on the floor

Exit roller

• 1600mm exit roller

Electrical

• Main control panel is mounted on backside of washer on/off controls are mounted on front side of washer -220 volt, 3 phase, 60 Hz